| MFI(4) | Device Drivers Manual | MFI(4) |
mfi — LSI MegaRAID
SAS driver
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device pci
device mfiAlternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
mfi_load="YES"
This driver is for LSI's next generation PCI Express SAS RAID controllers. Access to RAID arrays (logical disks) from this driver is provided via /dev/mfid? device nodes. A simple management interface is also provided on a per-controller basis via the /dev/mfi? device node.
The mfi name is derived from the phrase
"MegaRAID Firmware Interface", which is substantially different
than the old "MegaRAID" interface and thus requires a new driver.
Older SCSI and SATA MegaRAID cards are supported by amr(4)
and will not work with this driver.
Two sysctls are provided to tune the mfi
driver's behavior when a request is made to remove a mounted volume. By
default the driver will disallow any requests to remove a mounted volume. If
the sysctl dev.mfi.%d.delete_busy_volumes is set to 1,
then the driver will allow mounted volumes to be removed.
A tunable is provided to adjust the mfi
driver's behaviour when attaching to a card. By default the driver will
attach to all known cards with high probe priority. If the tunable
hw.mfi.mrsas_enable is set to 1, then the driver will
reduce its probe priority to allow mrsas to attach
to the card instead of mfi.
mfi does not provide ATA TRIM support.
Refer to mrsas if TRIM support is required.
The mfi driver supports the following
hardware:
The mfi driver first appeared in
FreeBSD 6.1.
The mfi driver and this manual page were
written by Scott Long
<scottl@FreeBSD.org>.
The driver does not support big-endian architectures at this time.
| March 13, 2019 | Debian |